3pairs XT30 Plug XT-30 Male Female Connectors Cable with 16awg 10cm Slicone Wire for RC LiPo Battery FPV Turnigy/Zippy(CC12-3)

Product Information

This is why it is important to use the proper connectors and wire gauges. (Tips: Obtaining the proper wire gauge and connectors can extend the life of the device.) The GNB27 displayed similar performance to the BT2.0 and A30 in our testing, and it’s slightly heavier, so it makes more sense to use BT2.0 or A30 for tiny whoops and other 1S micros. Additionally, in my experience, the GNB27 connector is a bit harder to use than BT2.0, as it’s really tough to pull apart when swapping batteries. A30 and BT2.0

Made from high-temp Nylon and gold plated spring connectors, both are included in the same injection mold at the time when forming the connector. The XT30 ensures a solid high-amp connection, perfect for applications up to and beyond 35A constant.

XT60 Female Connector & Wire 10cm

When you charge your battery this way, all the current will go through these two wires in the balance lead, instead of the discharge lead, as shown in the image below. During the test, the battery was discharged at a constant current of 12A, until the voltage dropped to 6V (3.0V per cell). This 12A load is a reasonable representation of the demands placed on a 1S or 2S micro quad. A typical tiny whoop draws fewer amps than this. Using the adapter, basically you are “cheating” the charger that the two outer wires in the balance lead are the discharge lead. (in fact these two wires are connected to the same solder joints inside the battery as the discharge lead, you can confirm with a multimeter in continuity mode) We have a similar topics on the forum if you’d like to learn more about this subject and like to comment. Edit History There’s also voltage rating for electrical wires, but it’s usually not a concern for RC applications, since the voltage we are dealing with are well below 30V. The wires we use can tolerate much higher voltage (e.g. hundreds of volts or even higher). Where to Buy Silicon Electrical Wires

Deans: Medium-sized. Perfect for larger RC cars (1/8, 1/10 scale), boats, drones, and RC planes with a wingspan over 1m. Best paired with 3S, 4S, and 6S LiPo batteries with capacities over 1500mAh. Durability & Lifespan I agree as well... for anything 100-200 grams or so with 7-20A draw, they are the only choice. I started with them on my Tarot TL130; they turned a floaty, poky little porker into a tight little beast.

XT30U Female - Yellow

While the XT60, a member of the XT series, is widely regarded as a technologically advanced successor to the Deans, it’s crucial to note that many RC manufacturers still prefer the Deans due to its cost-effectiveness. This affordability makes the Deans plug a preferred choice for many, despite the rising popularity of the XT60 in various RC models and chargers. Usability If you don’t have any spare, these connectors are cheaply and widely available. Select balance lead based on the LiPo cell count, and use XT30 or XT60 depending on what’s on the parallel charging board. Physical properties: In terms of softness, the silicone wire is relatively soft. And PVC is relatively hard. At low temperatures, PVC wire is softer than silicone wire. You have the right to access your personal data and request it to be corrected, deleted, or limit its processing; To maintain consistency throughout the testing, I chose to use the same battery for all the connectors (a 2S 300mAh LiHV battery). The original connector on this battery was replaced with the connectors under test.